金屬切削仿真中采用自適應網格時出現不能使用單元畸變控制

hlhchina

" b" N+ E# L3 j7 m% I4 w我在做金屬切削仿真，在金屬切削仿真中采用自適應網格，但是在網格檢查時出現自適應不能使用單元畸變控制！！！
" j% `2 j7 a9 g- D& S/ a' j. m問題描述如下：
Adaptive meshing is not supported for elements used with the distortion control.
- e6 _6 @. n/ I3 H# g( {Domain name: assembly_adapt
Abaqus/Explicit Packager exited with an error - Please see the  status file for possible error messages if the file exists.
9 J, s3 \  e0 v
# `8 a$ x+ l0 S% G3 a但是不用網格畸變控制吧，又出現了網格畸變問題：
) r8 Z7 L7 F8 g, u  SThe elements contained in element set ErrElemExcessDistortion-Step1 have distorted excessively.
4 G' G* n" _$ {The elements in element set ErrElemZeroALEMass-Step1 have zero or negative mass.
. ?) M* v* E1 r. y% u$ O4 SPrint-out suppressed for subsequent distorted elements
2 Q# K! m2 H9 ~% S1 B( T0 k6 I" ZThere are a total of        60 excessively distorted elements.
, @5 y; W) Q" x  V7 o! d/ f# U請求各位達人幫助，萬分感謝！！！
  s# M& L, C/ C; y$ m

閑庭信步逸

有人回復嗎
1 j8 o8 Y5 k: ^9 G5 i4 L1 N

AdaptER

老哥，您這個問題解決了嗎？