我想在現有的生產線彈簧受力程序中添加一段計算平均值的程序，原程序僅讀取一個隨機值然后輸出。$ H* E$ y* B6 `1 Q" ^5 n% l7 @, @: I
因為彈簧受力有小幅度的震蕩，所以我想讓程序讀取10個值，然后算出平均值輸出。
# e" j, \1 r- |8 T9 z! M關于提取測量數據計算平均值的程序，小弟實在是學得太少。。只會輸入幾個數求平均值的程序。+ L6 r" w) X* s/ f" j
下面這段是原程序，感謝進來幫忙的高手們！！
4 C4 w) ?0 H! s3 @ JU S_00; / / Wait for release
! z% Y8 q/ ~2 }$ T$ L" W0 V JU S_01; / / Read controller status and decide whether to start is needed.
' s; k& z8 ~1 H8 E& C1 w; s R JU S_02; / / Start CanOpenNode (if necessary) then return to Step 1.
! F5 l/ ?3 v0 M& i2 J) w JU S_03; / / Reserve Step ( n j8 T& q0 q7 `% p) E
JU S_04; / / Read current position in increments / q/ \- h4 M6 B+ l& q
JU S_05; / / Read current limit set in mA
I, L' I C: q6 G6 J1 V. K7 k5 T$ \9 x JU S_06; / / Read current flow in 1 / 1000 to current limit 7 m1 [( i4 `& L& }" E9 K; U
JU S_07; / / Read back * _% K* M) H& e; b, ^
JU S_08; / ??/ Read back $ |$ S4 s' m' h& q* r
JU S_09; / / Read back
& W. a! C/ X" \. D' W5 e6 i1 A. n0 _/ b JU S_10; / / write the forward position 6 n7 x% Z/ h' K s" Z* ^) V# m; @
JU S_11; / / Write back position . R0 w# _3 N& g0 d* l
JU S_12; / / Write Maximum Test Current " w0 _0 @# M$ ]/ H
JU S_13; / / write back 5 b: l% ]( p7 V" N4 Z
JU S_14; / / write back
& |; G3 r( @6 d: |& z" l+ u/ A8 V JU S_15; / / write back $ l0 z9 T) Q. `8 l$ D$ z
JU S_16; / / write back 9 P+ m. n# G- r
JU S_17; / / write back
) N5 I1 P7 n; a( Z, ^) I: L$ X |
發表于 2011-5-16 20:32:38
QQ好友和群
QQ空間