一臺德克磨床的英文資料---請教

老軍工

Type 1
% T1 S2 V" F0 C, w! JFlutes with individual infeeds of depth are different in length ,but do have the same point of exit at tool periphery .
Type 2
7 c% T, g- a5 r, mFlutes with individual infeeds of depth have the same length ;therefore different points of exit at periphery.

6 S7 L% g, L, o% A* w" s) k求助各位老師：本人是數控磨床操作工，

hyj_9766

用網絡在線翻譯

英德康

原帖由 老軍工 于 2008-9-30 20:06 發表
Type 1
Flutes with individual infeeds of depth are different in length ,but do have the same point of exit at tool periphery .
/ b6 c3 m" Z$ Y$ l. L' C& [- u4 CType 2
Flutes with individual infeeds of depth have the same length ;t ...

老軍工你好，對你的專業不熟，譯文僅供參考，
第1類
# U$ c( U7 F, A" N( R& k對于個別橫切深度的凹槽，長度不一樣但刀邊出位一樣，
第二類，
7 _% G; \+ |8 ?0 _對于個別橫切深度的凹槽，長度一樣但刀邊出位不一樣，