本帖最后由 達文中 于 2022-7-21 08:51 編輯
8 j5 H W% b/ T# j
! O) Q" M% A" Y( n- q' L* `之前用SolidWorks 2019，最近更新到2021，也遇到同樣的問題。
! H) o& u8 X5 S3 n+ H, ]* W( e3 I6 y
網上找到了解決方案，記錄如下：
( B# Y# f$ V/ {3 l8 B0 ~# S( S. {* s" W* p8 w" X, n) a5 j
/ j+ {9 N$ T3 @2 mSolidWorks 2021 Pack and go 功能無法啟用: y: m: \ e5 x* M
2 A8 K' N0 Z; r: x. x0 i$ [
Pack and Go Nothing Happens
. D# f6 D. g) N用戶 Gordon KistlerSOLIDWORKS User Forum2022-05-05
+ z. ~" h9 H4 G& ^* bI am using SW2021 SP5.1, freshly installed by my IT department. When I try to do a Pack and Go from within SW, nothing happens. When I try Pack and Go from within Windows Explorer, I get the spinning circle but nothing else. Suggestions?
l: w* w4 i$ }, o- Z
& K9 G) }' W3 Q2 t' K) f' L# l3 ]Gordon Kistler - 2022-05-09$ e& |) z d2 o# g5 W* ?1 u$ r
Resetting the registry and then restarting SolidWorks took care of the problem. Thank you!
$ x' r$ w, t _! _' R) u
9 K% V, a5 G5 R# X% D8 l8 MLink From：<https://r1132100503382-eu1-3dswym.3dexperience.3ds.com/#community:yUw32GbYTEqKdgY7-jbZPg/iquestion:e_-F0_riRuKyo78xKK3bgQ>! l: j/ h( o9 J, ]* i! J
! J$ P7 ^9 [3 k$ \+ U+ z+ ?% ~
" w* J2 H3 j) \3 C可以看到是因為注冊表有問題，那怎么更改注冊表？' m, i) ^3 l) h
. V Y+ J) L, M7 sHow to Reset SOLIDWORKS by Resetting the Registry Entries (javelin-tech.com)
* [- D' G0 q4 |3 u/ G- @( msee link <https://www.javelin-tech.com/blog/2019/01/reset-solidworks-registry/>
; G) X* v; A$ n& G% s' G" K& e. O& E+ s4 f& [
|
發表于 2022-7-20 17:16:49
QQ好友和群
QQ空間
