久久久国产一区二区_国产精品av电影_日韩精品中文字幕一区二区三区_精品一区二区三区免费毛片爱

機械社區

標題: 一臺德克磨床的英文資料---請教 [打印本頁]
作者: 老軍工    時間: 2008-9-30 20:06
標題: 一臺德克磨床的英文資料---請教
Type 1
, ?' R9 k8 [  a* I: T9 QFlutes with individual infeeds of depth are different in length ,but do have the same point of exit at tool periphery .5 a3 k, p7 n+ @# q
Type 22 q- d& S; V) k5 b
Flutes with individual infeeds of depth have the same length ;therefore different points of exit at periphery.
- T5 h# s5 R3 N) t- E7 t3 K% A# \0 u# D$ X: F7 p" }/ j! t
求助各位老師：本人是數控磨床操作工，
作者: hyj_9766    時間: 2008-10-4 20:29
用網絡在線翻譯
作者: 英德康    時間: 2008-10-19 02:47
原帖由 老軍工 于 2008-9-30 20:06 發表 3 w+ L9 o* l* t9 J/ H3 W! r, M
Type 1
; ^) L3 l3 z( e1 w( Y) AFlutes with individual infeeds of depth are different in length ,but do have the same point of exit at tool periphery .
; m5 X0 n: T) a) z) A6 p0 ZType 2' @& b5 _* g  y
Flutes with individual infeeds of depth have the same length ;t ...
2 {  z2 M7 j" K; S# U1 d) `7 N7 O5 x
老軍工你好，對你的專業不熟，譯文僅供參考，
$ m4 K& ]1 E+ o, G9 ]1 M" r第1類0 }0 b/ m2 l- @" w: ]& H5 ?9 X9 {
對于個別橫切深度的凹槽，長度不一樣但刀邊出位一樣，
0 P! I0 _, l5 \# `第二類，# C  I" C, C2 `4 _: M" ^& A+ P
對于個別橫切深度的凹槽，長度一樣但刀邊出位不一樣，



歡迎光臨 機械社區 (http://www.ytsybjq.com/) Powered by Discuz! X3.5