機械社區
標題: 創造是將世上已知的東西不斷組合 [打印本頁]
作者: qqa007 時間: 2011-10-2 01:12
標題: 創造是將世上已知的東西不斷組合
世界上第一個
太陽能供電的
3D打印機( T* C+ y# m5 m
& T+ n* g" Q9 L9 x# W: B" k
為了保持最低的能源需求，設備并不需要一臺電腦進行操作。相反，三維模型，是通過SD卡打印
& Z% A" ]. P( o# i8 }% Z9 ?( ~4 ^發明者希望，他的廉價，簡易的打印機將在偏遠地區訪問備件" i; _: b: k# [. V
0 O4 Q& j, G) U
作者: qqa007 時間: 2011-10-2 01:15
光合作用是用來記錄圖像
作者: fmdd 時間: 2011-10-2 08:46
怎么將SD卡里面存儲的模型，變成可以讓打印機識別的指令？這個運算量很大，讓打印機來處理么？連PLC都很難處理過來，太陽能供電的打印機芯片就更不靠譜了，除非將模型先期在PC上轉換成可識別的指令，比如G代碼。. }4 E* `6 o. _- m0 F+ m. Y
- l1 M; E7 w% h7 \) S
intel在研發低能耗的芯片，可以用太陽能驅動，功率50mW，目前只有一個樣品，性能低下，離實用還有很長的距離
作者: qqa007 時間: 2011-10-2 09:45
fmdd 發表于 2011-10-2 08:46 
( U h; S( c3 A' {& D! C8 ]怎么將SD卡里面存儲的模型，變成可以讓打印機識別的指令？這個運算量很大，讓打印機來處理么？連PLC都很難處 ...
, j! k0 Y. ^- Y1 b4 VHack A Day reports that a hobbyist inventor, simply called Mark, has claimed to have created the world’s first solar-powered 3D printer. The device is based on an open-source RepRap Mendel 3D printer than can be assembled at home from commercially available pieces. Mark connected the DIY printer to a 40-watt solar panel and two batteries, which can power the device without any help from the grid.
To keep the energy requirements to a minimum, the device doesn’t need a computer to operate. Instead, the 3D model is fed to the printer via an SD card. The inventor hopes that his cheap, improvised printer will prove useful in remote areas where access to spare parts is often very difficult.
" b6 l+ Y! i( I; h1 A' Y
作者: 魚尾獅 時間: 2012-12-1 16:21
太好了，頂。。。
作者: 志不窮 時間: 2013-8-25 22:23
三Ｄ打印是未來核心，不過還要不繼的完善。- s7 F( }& V1 `
| 歡迎光臨 機械社區 (http://www.ytsybjq.com/) |
Powered by Discuz! X3.5 |